ระบบละลายด้วยเลเซอร์

Renishaw RenAM 500 S-FLEX

Processable materials: Metals in powder form. These include, for example, stainless steels and tool steels, aluminum alloys,
nickel-based alloys and titanium alloys.
You can find more information about materials and surface quality on our homepage.
Weight (net): 1,870 kg
Laser type: Ytterbium fiber

Laser power: 1 × 500 W

Dimensions: 2,165 mm x 1,236 mm x 2,130 mm (L x W x H)

Build space (1) 250 mm × 250 mm × 350 mm (L x W x H)

Powder layer thickness: 20 μm to 120 μm

Typical process speed (3): 2 m/s (max. 10 m/s)

Build rate (2): Up to 254 cm³/h

Beam focus diameter: 80 μm with dynamic focus

Dynamic focus diameter: Up to 500 μm

Beam wavelength: 1,070 nm to 1,080 nm
Laser modulation frequency (max.): 20 kHz
Build chamber atmosphere preparation time: 15 minutes (to < 1,000 ppm oxygen content)
Filling/emptying system consumption: < 1,200 l
Maximum argon consumption (during filling): 400 l/min
Ongoing argon consumption (after initial filling): < 0.8 l/min
Working pressure in chamber: 10 mbar to 20 mbar
Argon gas supply connection: 3/8 in BSP male connector
Argon quality: 20 ppm permissible impurity or better (99.998% purity)
Power supply (4): 380 V to 480 V AC, 63 A, 50 Hz to 60 Hz, 3-phase
Data connections (5): Standard RJ45 network connection. Renishaw recommends using Cat 6 power cables.
Ideal operating temperature (7): 18°C to 22°C (min./max.: 15°C to 28°C)
Ideal relative humidity (7): < 60% (max. < 80%)
Clearance under machine (excluding base): 146mm
Optical module protection class: IP5X
Noise level: ≤ 70dB
Compatible software: QuantAM, InfiniAM Camera, InfiniAM Spectral, Renishaw Central and selected third-party software

(1) Build volume refers to the maximum build volume from wall to wall, however the usable area is usually smaller. The
substrate plate is not included in the dimensions.
(2) Maximum build rate does not include coating time and is dependent on parameters, part geometry and material.
(3) Typical process speed depends on parameters, part geometry and material.
Guedpfxov Ewpns Ahuoh
(4) The calculated maximum load of the machine is 50 A, the nominal operating current is 32 A.
(5) The user has the option to configure the network with their own control software. For more information
see the RenAM 500 Series Additive Manufacturing System User Manual, Renishaw Part No. H-5800-3693.
(6) Due to different electrical requirements in each country, the part numbers for the
accessories may vary. Contact your country's customer service department if you have any questions about this.
(7) Temperature and humidity must not be at the maximum specified at the same time and must remain below the value
at which the dew point reaches 16 °C (61 °F) to avoid the formation of condensation on the laser components. See Site Preparation and Installation Guide for the RenAM 500 Series Additive Manufacturing System,
Renishaw Part No. H-5800-3692.

โฆษณานี้ได้รับการแปลโดยอัตโนมัติ อาจมีข้อผิดพลาดในการแปลได้